"fw ctl get int fwha_perform_chain_forward" command failed

[Chinmaya_Naik]

Hi Team,

When I run the below command showing "Get Operation Failed".

"fw ctl get int fwha_perform_chain_forward"

Security Gateway OS : R80.30 (Take_196 JHF)

What is the use of this command ?

is this command not relevant in R80.30 ?

Regards

@Chinmaya_Naik 

[Guy_Elyashiv · Accepted solution]

Hi,

This command was used to enable or disable the "forwarding mechanism", this mechanism was deprecated in R80.20 and was replaced by a new mechanism called "correction layer" which is always enabled, therefore the commands mentioned are no longer available.

[Chinmaya_Naik]

@Guy_Elyashiv

Thanks for the update.

How can I checked that "correction layer" is enabled.

is there any command or any file location ?

[PhoneBoy]

It’s not a feature you can “disable” so it doesn’t make any sense to have a command to check the status of it.