Lisense Enquiry

[Danny_Lim]

Hi, 

1./ If customer was using EndPoint Security on UTM-1 272, version R75.40. 

2./ Customer license contain CPSB-VPN ( refer License.png ), and customer able to form the mesh VPN successfully. 

3./ At the SmartView Monitor, I noticed the All Active Tunnel Peak only set to 5 ? Does it mean the EndPoint Security only able to support 5 tunnels but not limited to how many user(client) to connect ?  

4./ If customer using CheckPoint EndPoint Client to connect, how many user are allow to connect to this IPsec VPN ? The reason i'm asking is customer advised they are able to connect more than 5 EndPoint Client, which obviously doesn't mean of "All Active Tunnel Peak" on Point 3. 

5./ The following datasheet shown the number of user was unlimited and VPN throughput was 120Mbps. 

Means i only have 5 active tunnels but i can have unlimited client to connect with maximum throughput 120Mbps ? 

https://www.checkfirewalls.com/datasheets/appliance-comparison-chart01.pdf

I can't found any more useful information about the CPSB-VPN license. 

[_Val_ · Accepted solution]

Several points.

1. UTM-270 series are out of support since 2015

2. Your license only allows 5 Remote Access users to be connected. Hence 5 tunnels

3. CPSB-VPN is for S2S, not remote access

[G_W_Albrecht]

This - very old - license is invalid as its support has ended 01-Jun-2016. As the appliances Purchase Date has been 31-Mar-2011, this is historic hardware ready for a museum only 😎