AnsweredAssumed Answered

Does spillover feature is available in endpoint security 730 appliance

Question asked by Monish Bhaskaran on Aug 22, 2018
Latest reply on Aug 28, 2018 by Monish Bhaskaran

Like • Show 2 Likes2
Comment • 2

Hi all,

I am new here, I am working on an endpoint security 730 appliances. Right now, two ISP's have been configured. I want to know to how to configure spillover in such a way that when primary ISP's bandwidth is fully utilized and the traffic should be automatically shifted to the secondary ISP.

Thank you in advance.

No one else has this question

Outcomes

2 Replies

Dameon Welch-Abernathy Aug 26, 2018 9:30 PM
Mark Correct
Correct Answer
You can configure an Internet connection to receive a percentage of the Internet traffic in the Advanced tab.

re

However, there isn't an option to start using the secondary Internet connections only after you've used the bandwidth of the primary connection, which I imagine would be difficult to measure in practice.
1 person found this helpful
Like • Show 1 Like1
Actions
- Monish Bhaskaran @ Dameon Welch-Abernathy on Aug 28, 2018 1:29 AM
  Mark Correct
  Correct Answer
  Dameon Welch-Abernathy Thank you for the reply. Our network is already running on 70-30 load balancing as you have suggested. Was just wondering if something like that was possible. Thank you again.
  Like • Show 0 Likes0
  Actions

Does spillover feature is available in endpoint security 730 appliance

Outcomes

Related Content

Recommended Content