I am unable to access the GUI for the checkpoint. Have set VMnet 0 in the same IP range of my laptop which is 192.168.1.x and i am still unable to access it
Yes, i have tried to auto bridge. But again when you check the network preferences the autobridge setup vanishes
Notice the notice at the bottom of the screen: Administrator privileges are required to modify the network configuration.
Do you have such privileges?
If not, that might be why it's not working.
No, i am the admin and i have done change settings. I think the settings is not being applied. So thats the reason i ain't able to access the GUI.
Any insights is appreciated.
Is it necessary to set a gateway while assigning IP to management interface?
I am removing the gateway IP entry, so can that be an issue?
Retrieving data ...