ISP Redundancy with 3 ISPs

[Jan_Gilla]

Is there a way to add a third uplink to the ISP Redundancy feature? At the moment we have two uplinks configured but we would like to add a third uplink.

[PhoneBoy]

ISP Redundancy only supports 2 ISPs.

[Jan_Gilla]

Are there any plans to remove this limitation?

[PhoneBoy · Accepted solution]

I’m not aware of specific plans. Perhaps this will be addressed in Policy Based Routing in the future.

[Jan_Gilla]

Thank you very much!

[joshua_gt]

Hello, is this limitation for all versions including R81.10?

[PhoneBoy]

This is a limitation of ISP Redundancy in all versions, yes.
I don’t believe this will apply to the Quantum SD-WAN functionality, however.

[joshua_gt · Accepted solution]

Thank you for your prompt response,

I'm doing some research and I see that for the 81.10 versions you can already have up to 10 links, I leave the official sk112200 sk112200

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut... 

[PhoneBoy]

I had forgotten about that addition to R81.10 🙂

[Jones]

Hi,

sk25152 describes a script for two ISP's in a loadsharing solution with two ISP's in loadsharing. So what about a High Available solution with three ISP's, that should also be possible. What lines in the cpisp_update are then needed for this solution?

Grtz Jones

[Jones]

I got a reply from Check Point support. They updates sk25152 and gave me the cpisp_update lines for 3 ISP's that I added it in this post. Don't forget to add two extra lines on the CLI:

dynamic_objects -n DYN_ISP_C
dynamic_objects -o DYN_ISP_C -r 0.0.0.0 0.0.0.0 -a