Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Don_Paterson
Advisor

atp command and more on Autonomous Threat Prevention commands

The Threat Prevention Admin Guide seems to have no reference to the atp command.

I discovered and used 'atp status' command but cannot find anything interesting on it.

A reboot was the fix but still not sure what caused the ATP SmartConsole error.

See attached.

 

References:
https://sc1.checkpoint.com/documents/R81.10/WebAdminGuides/EN/CP_R81.10_ThreatPrevention_AdminGuide/...

 

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

 

https://community.checkpoint.com/t5/Threat-Prevention/Autonomous-Threat-Prevention-service-is-down/t...

 

 

 

0 Kudos
4 Replies
PhoneBoy
Admin
Admin

I do see a reference to atp commands here: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut... 
However, you're right: there doesn't appear to be any documentation on these commands.

0 Kudos
Don_Paterson
Advisor

Yes, it is referenced there but only to show 'atp restart', and nothing else (no links or explanations).

As expected the atp command, when it is run on it's own, shows the 'usage' but the documentation on it is nowhere to be found.

Thanks for getting back to me.

 

 

 

0 Kudos

More information is available in the ATRG for Autonomous Threat Prevention:

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

 

In the past the product name was Infinity Threat Prevention hence all the command are use itp.

I will ask for the SK to be updated to use atp.

0 Kudos
Don_Paterson
Advisor

Thank you 🙂

I knew it was previously itp but did not think to search itp status in Support.

I just ran 'autoupdatercli show' and noticed that ATP components all fall under the header 'product-name: itp' .
Small thing.

Regards,

Don

0 Kudos