Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Karlis_Erglis
Contributor
Jump to solution

Preboot Auth after hibernation

Is it possible to enable CP EPS to ask again user to enter credential in Preboot when computer is resumed from hibernation?

 

At this moment when computer is resumed from hibernation, it boots directly to Windows. In this situation we have one protection layer less for our data.

0 Kudos
1 Solution

Accepted Solutions
Karlis_Erglis
Contributor
Yes, you were right. 🙂 After config recheck, i found that computer where put to sleep, not to hibernate mode.
One of out GPO policy turned of hibernation.

After turning hibernation ON, PreBoot password screen appeared.

1) powercfg /hibernate on

Next, run the following command to change the hibernation file type to full (if needed).
2)powercfg /h /type full
3)Reboot and change Power Settings.

View solution in original post

0 Kudos
2 Replies
PhoneBoy
Admin
Admin
As far as I know, if the laptop hibernates, the pre-boot screen should come up.
At least it does for my laptop. 😁
Are you sure your laptop is fully hibernating and not just sleeping?
Hibernation takes a minute or more to resume, sleep usually just a few seconds.
0 Kudos
Karlis_Erglis
Contributor
Yes, you were right. 🙂 After config recheck, i found that computer where put to sleep, not to hibernate mode.
One of out GPO policy turned of hibernation.

After turning hibernation ON, PreBoot password screen appeared.

1) powercfg /hibernate on

Next, run the following command to change the hibernation file type to full (if needed).
2)powercfg /h /type full
3)Reboot and change Power Settings.
0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events