Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
the_rock
Legend
Legend
Jump to solution

Issue with SmartMove conversion tool

Hello everyone,

 

Im not sure if this is the right board to post this or if anyone can help, but figured would try. I used smartmove before and worked well, but have an issue where a new customer gave me the cisco asa config and for some reason, converts all the objects fine, BUT when it comes to rules, though there are around 300, it only shows 4, which makes no sense.

 

I compared the runn config file with another customer's file that worked and I cant see any major differences, except new config is much larger, but that should not really matter.

 

If anyone has any ideas, please message me offline, as I cant sadly provide the config file here, due to security reasons.

 

tx a lot

 

Andy

0 Kudos
1 Solution

Accepted Solutions
PhoneBoy
Admin
Admin
0 Kudos
3 Replies
PhoneBoy
Admin
Admin
0 Kudos
the_rock
Legend
Legend

Thanks as always Dameon, appreciated the fast response. I will keep checking, but its just odd that its not working...

 

Andy

0 Kudos
the_rock
Legend
Legend

issue fixed...in case this helps anyone, here is what I asked customer to do:

 

From cisco enable mode, run conf t and then this:

pager 0

wr mem

 

What this does is actually enforces any commands to run continuously without having to press space bar. Once client did this and generated show runn, they sent the file and I was able to import everything into smartmove.

 

Thanks guys and be safe!

 

Andy

0 Kudos
Upcoming Events

    CheckMates Events