NAT Rule not working

[Deepakrawat10]

I created a NAT rule by taking RDP from outside. When we connect the RDP and enter the password it automatically disconnects and not working properly.

[G_W_Albrecht]

I can not see the topology used here and what shall be achieved by the NAT rule ?

[PhoneBoy]

If you only want to allow RDP to a specific host, it should be done via the Access Policy.
Your NAT rule should only contain services if the port itself needs to be changed.

And yes, an actual topology diagram would help (you can use fake IPs).

[Gaurav_Pandya]

You can verify that NAT is happening or not by below command,

fw ctl zdebug + xlate | grep <ip address>

Need to understand exact topology if it is not working.