Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
gyogesh
Explorer

unable to ping checkpoint management IP when VM started from gns3

Hi,

I am unable to ping checkpoint management IP address when i start checkpoint VM from gns3 2.2.8. 

192.168.43.20 is the management IP. Also unable to access web gui - https://192.168.43.20

Getting below when i ping 192.168.43.20

reply from 192.168.43.89 : destination host unreachable

reply from 192.168.43.89 : destination host unreachable

reply from 192.168.43.89 : destination host unreachable

but if i start checkpoint VM from Virtual Box only I am able to ping the management IP also able to access web gui - https://192.168.43.20

Getting below when i ping 192.168.43.20

Reply from 192.168.43.20: bytes=32 time<1ms TTL=64

Reply from 192.168.43.20: bytes=32 time<1ms TTL=64

Reply from 192.168.43.20: bytes=32 time<1ms TTL=64

I am using Checkpoint r77.30 

Please suggest

 

 

0 Kudos
4 Replies
PhoneBoy
Admin
Admin

gns3 is not a virtualization environment we officially support.
That said, there are threads on CheckMates where people were using it with later releases of Check Point.
And, honestly, you should be as well since R77.30 is End of Support.
gyogesh
Explorer

Thanks for replying.
It worked . Issue was with the network adapter settings.
0 Kudos
PhoneBoy
Admin
Admin

You might want to share what precise settings were incorrect so others can learn from your experience.
0 Kudos
gyogesh
Explorer

Thanks for your response 

For the Management Server 

Network Adapter 0 should be bridged - make sure you choose the right adapter what you use for the ethernet or wifi

Network Adapter 1 should be Vmnet 1 - Coz you are connecting other interface to Gateway 

 

For the Gateway

Network Adapter 0 should be bridged - make sure you choose the right adapter what you use for the ethernet or wifi

Network Adapter 1 should be Vmnet 1 - Coz we need to connect gateway to Management server. so it is going to be the same Vmnet1 we used for management server.

and Network adapter 2 - Vmnet2 - if you are connecting it to any other network. in my case i am using gns3 router 

 

once you start from gns3, Vmware adapter settings changes automatically. coz gns3 itself assumes the required adapters to start the VM in which it takes other than required adapters. that causes connectivity issues between 2 Vms which further require manual correct adapter settings. 

 

 

 

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events