disconnect link from an interface r77.30 VSX clusterXL

[Sergio_Ordaz]

Hello you all, 

I was asking to disconnect an interface used by a virtual system in a vsx cluster, this interface is not for sync, it is just for traffic in general.

There is a way to guarantee that there will not occur a fail-over once I disconnect the link from that interface?

Regards.

[Maarten_Sjouw]

Before disconnecting, on the backup gateway in clish:

set vsx off

set interface eth02-2 state off

set vsx on

save config

repeat the above commands on the primary gateway, then you can disconnect without any problem.