Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
check3r
Explorer
Jump to solution

commands not being accepted on command line cli gaia 77.20

 

I am runnning the following commands on a checkpoint device running in VSX mode.

I just want to change ip address of existing interface and also add some new static routes but the commands aren't being accepted.


xxx:0> set interface eth1.400 ipv4-address x.x.x.x mask-length 24
CLINFR0699 Invalid command.

same this happens set static-route command

Any reason why these commands aren't valid or am i missing something

Also when i look at the config of the devices these are the commands being used to configure interfaces and static routes

Thanks for any help

 

0 Kudos
5 Replies
This widget could not be displayed.

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events