ckp loading fw1 ipv4 instance 0 failed

[Geomix7]

Hello Guys ,

We performed an upgrade through CPUSE to version R80.40 from R80.20.After finished the upgrade in the reboot the device shows the message below :

ckp loading fw1 ipv4 instance 0 failed

Any suggestions?

Thank you

[PhoneBoy]

Any behaviors to go with it or just the error message?

[Geomix7]

We solve it by entering maintenance mode , and find out in messages that this error cause by parameter parameter ccl_preserve_src_MAC  .

We remove it , reboot and works properly.

Thank you

[NabilGates]

Hello,

I just installed R80.20 on a virtual machine. At the end of the installation, everything works as expected, but once I restart the machine, I get this error message:

CKP: Loading FW-1 IPv4 Instance 0: FAILED

I am a beginner, so I am not able to apply your advice. If you could detail the steps to solve my problem, I would be very grateful.

Thank you in advance.

[PhoneBoy · Accepted solution]

Is it R80.20 (which is End of Support) or R81.20?
In any case, what are the specifications on the virtual machine you attempted to install this on? (Disk space, cores, RAM)

[NabilGates]

Check_Point_R80.10_T479_Gaia.iso

[PhoneBoy]

R80.10 is even more End of Support.
In any case, this does not meet the minimum requirements, which explains why this is failing.
We offer a video that explains how to install an entire environment in VirtualBox: https://community.checkpoint.com/t5/Member-Exclusive-Content/How-to-Learn-Check-Point-Quantum/m-p/17... 

[Lesley]

I think you gave to little memory or CPU

https://support.checkpoint.com/results/sk/sk116912

https://support.checkpoint.com/results/sk/sk173544

[NabilGates]

Hi,

one  cpu

4Go memory !

20go disk

[NabilGates]

[_Val_]

You need to have at least 8 GB RAM for normal work. Also, Why are you trying to install R80.10? It is an obsolete version without any support for a long time.