- Products
- Learn
- Local User Groups
- Partners
- More
CheckMates Fifth Birthday
Celebrate with Us!
days
hours
minutes
seconds
Join the CHECKMATES Everywhere Competition
Submit your picture to win!
Check Point Proactive support
Free trial available for 90 Days!
As YOU DESERVE THE BEST SECURITY
Upgrade to our latest GA Jumbo
The 2022 MITRE Engenuity ATT&CK®
Evaluations Results Are In!
Now Available: SmartAwareness Security Training
Training Built to Educate and Engage
MITRE ATT&CK
Inside Check Point products!
CheckFlix!
All Videos In One Space
I was preparing 2 12400's for installation, 1 was clean installed with R77.1 and 1 had a used R77.30 installation on it.
I copied the deployment agent 1573 onto it, updated CPUSE and copied the Check_Point_R80.10_T462_Fresh_Install_and_Upgrade_from_R7X.tgz file, which I then imported.
Next step was installer clean-install <the imported package> and let it run and reboot.
All looked fine untill I was looking at the Mgmt interface, it had kept it's IP, and the default route and this is where it gets weird:
gw-7> show configuration static-route
set static-route default nexthop gateway address rt219bb100-100- on
I tried to add the correct route:
gw-7> set static-route default nexthop gateway address 100.100.219.9 on
RTGRTG0019 syntax error
With show route no routes are shown.
Adding any static route will just give me the same syntax error??
First I tried to clear the Gaia config by deleting the config database, cd /config and rm-r * However this did not change anything in th IP fielde.
Ok, found a workaround to the problem:
Go into expert mode and edit the file /etc/routed0.conf and make sure the correct next hop is entered there with the default gateway.
Now start the First time wizard and when it shows fill out the correct default gateway there as well, now finish the FTW and all is back to normal.
About CheckMates
Learn Check Point
Advanced Learning
YOU DESERVE THE BEST SECURITY