- Products
- Learn
- Local User Groups
- Partners
-
More
Celebrate the New Year
With CheckMates!
Value of Security
Vendor Self-Awareness
Join Us for CPX 360
23-24 February 2021
Important certificate update to CloudGuard Controller, CME,
and Azure HA Security Gateways
How to Remediate Endpoint & VPN
Issues (in versions E81.10 or earlier)
Mobile Security
Buyer's Guide Out Now
Important! R80 and R80.10
End Of Support around the corner (May 2021)
Dear, I-am use R80.10 cluster .My vpn through endpoint security was running normally, until I needed to activate ipsec on the cluster to proceed with a serial connection to the site with azure. It happens that now my client who are using the endpoint, needing to reconnect every time access was done, where he places the destination IP, user and makes the connection. If I try to reconnect it informs that it is loading new topology and disconnects, then I need to redo the tunnel again. Can you help me
Most likely the fact you had to enable IPsec VPN modified the Link Selection properties previously applied.
You can check the following SK to force Remote Access VPN through one address sk92383
Most likely the fact you had to enable IPsec VPN modified the Link Selection properties previously applied.
You can check the following SK to force Remote Access VPN through one address sk92383
Worked perfectly. Thank you very much
About CheckMates
Learn Check Point
Advanced Learning
WELCOME TO THE FUTURE OF CYBER SECURITY