Smart View Monitor displays status for all S2S VPN tunnels - Phase1 UP

[mjovovic]

Hi,

After upgrade from R80.10 to R80.40 version,  in SmartView Monitor app under Tunnels on GW we have all functioning S2S VPN tunnels shown with status - Phase1 UP. These tunnels are UP in both phases (IPSec SA's are created and app traffic tranverse smoothly through all VPN tunnels).

Any comments regarding possible reasons are welcome. Anyone had this "cosmetic" issue? 

Regards,

Milos

[Tobias_Moritz]

This was a known cosmetical issue with some older R80.40 JHF takes. See here:
https://community.checkpoint.com/t5/General-Topics/R80-40-IPSEC-VPN-shows-stuck-at-Phase-I-but-is-fu...

Are you sure you are on current JHF Take (T118 at the moment)?

[mjovovic]

Thank You Tobias. We will install JHF Take 118 and see if it helps.