RAID errors appear in /var/log/messages false positive?

[Geomix7]

Hello all ,

I run a health check on an appliance 5100  (R80.30) and receive "Raid Hardware recognition failed, Hardware is missing/not supported" message detected.
For more information, refer to sk91903.

By run the provided commands in the SK  i received the below output:

1.[Expert]# dmidecode | grep -i raid
OPROM - RST - RAID

2.[Expert]# cat /proc/mdstat
Personalities :
unused devices: <none>

I am trying to find out if this appliance has a raid controller or not but even by reading the datasheet I cannot find anything.

Does anyone know?

Thanks

[Juan_]

Hey,

Just disable the SNMP trap

sk119264

set snmp traps trap raidVolumeState disable

[Chris_Atkinson · Accepted solution]

The appliance only has a single disk hence RAID is not supported / relevant.