Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Danny
Champion Champion
Champion

R80.40 - CP Command to check if SMT is enabled

I'm on a Check Point 7000 appliance (datasheet) which has R80.40 JHF 55 installed and SMT enabled in BIOS.
/proc/cpuinfo shows 32 virtual CPU cores:
image.png
Which CP command will show me that SMT is actually enabled?
sk93000 suggests: cat /proc/smt_status
image.png
CLI R80.40 Reference Guide suggests: $FWDIR/boot/fwboot ht --enabled; echo $?
image.png
Of course there are ways to figure it out via /proc/cpuinfo but I'm looking for a Check Point command to simply tell if SMT is on or not.
0 Kudos
2 Replies
Timothy_Hall
Legend Legend
Legend

I noticed that original cat command to detect SMT stopped working in Gaia 3.10, try this:

cat /sys/devices/system/cpu/smt/active

1=active

0=inactive

Gateway Performance Optimization R81.20 Course
now available at maxpowerfirewalls.com
HristoGrigorov

There is also the 'show asset system' clish command:

...

CPU Hyperthreading: Disabled

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events