Partial config sync between Quantum spark 1800 HA

[CheckCheckM]

Hello all,

I'm facing some HA configuration issue between quantum spark 1800. I have done HA configuration using one sync link and one HA link (LAN1). When i swing primary to secondary, ipsec tunnel and ssl vpn configuration are missing at secondary device. is there any ha config is missing at mine? i used virtual ip address to login as management.

is anyone experienced that kind of issue?

Thank you.

 

[G_W_Albrecht]

Locally Managed ? You did deploy it following the cluster configuration steps ? Only the active node is configured, secondary is synced after FTW. This is different to GAiA...

[CheckCheckM]

Correct, it is locally managed. I deploy both firewall as primary first and secondary next step by step properly. When ha setup is done, i did ipsec tunnel and ssl config. Then, i swing primary to secondary. 

note: the same firmware version. Thanks.