Netflow active flow timeout?

[Paul_Warnagiris]

Hello Checkmates, I saw a few posts about active flow timeouts from 2018 and 2019.  The challenge I am having is two-part.  If I’m having a bandwidth issue, I have to wait up to 30 minutes to find out what is saturating the link. The other part is how SolarWinds displays that on the graphs. Sometimes it will show we have hit up to 5Gb in a single burst. So getting the flows every minutes make it a lot easier to see the difference between burst traffic and sustained traffic.  What we have is better than nothing, but it sure would would be handy if we could set this to every minute or every 30 seconds. Is there any possibility to change this behavior.

I did see sk130132, but I wasn't 100% sure if it was the same request.  Does anyone know if we can change this value?

Thanks,
Paul

[PhoneBoy]

Far as I know, this is not tunable on our end.
Requires an RFE.