- Products
- Learn
- Local User Groups
- Partners
-
More
Celebrate the New Year
With CheckMates!
Value of Security
Vendor Self-Awareness
Join Us for CPX 360
23-24 February 2021
Important certificate update to CloudGuard Controller, CME,
and Azure HA Security Gateways
How to Remediate Endpoint & VPN
Issues (in versions E81.10 or earlier)
Mobile Security
Buyer's Guide Out Now
Important! R80 and R80.10
End Of Support around the corner (May 2021)
Dear All,
Due to some reasons, we need to have below design:
Both Cisco switches have the LACP group 3 mode active for Port7 and Port8.
And we have two A-A clusters CPs with bridge mode [P1 and P2] trying to scan the LACP traffic.
We just find that both Cisco can not form the LACP now, any advice?
Without the CPs and if both Cisco directly connected [7<->7, 8<->8] the LACP will work back.
SW1:
SW2:
I don't think this is possible as LACP is negotiated by bridge/switch ports in a point to point fashion; you can't pass LACP generated by a switch port through a second switch/bridge to yet another port on a third switch, at least to my knowledge. You'll need to set up LACP on the Gaia interfaces as well to make this work.
About CheckMates
Learn Check Point
Advanced Learning
WELCOME TO THE FUTURE OF CYBER SECURITY