ElasticXL switch configuration for data interfaces ?

[Wolfgang]

Are there any special configuration on the switches needed for data interfaces ?

We're playing with ElasticXL and having some trouble after adding a second member. Most of the traffic does not go through the gateway. If we set one member down everything is fine. We can change the active node and all is fine. But with more then one node active everything stucks in nirvana or dev 0...

On the connected switch we get a lot of MAC flappings between Management and Data port.....

Mar 20 19:36:12.068: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0200 in vlan XX is flapping between port Gi1/0/9 and port Gi2/0/1
Mar 20 19:36:12.123: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0201 in vlan XX is flapping between port Gi1/0/1 and port Gi2/0/9
Mar 20 19:36:26.145: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0201 in vlan XX is flapping between port Gi1/0/1 and port Gi2/0/9
Mar 20 19:36:27.077: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0200 in vlan XX is flapping between port Gi2/0/1 and port Gi1/0/9
Mar 20 19:36:42.085: %SW_MATM-4-MACFLAP_NOTIF: Host 0000.0002.0200 in vlan XX is flapping between port Gi1/0/9 and port Gi2/0/1

Gi1/0/9 => Management-Port

Gi2/0/1 => Data-Port

What are these MAC-addresses ost 0000.0002.0201 and 0000.0002.0200

[_Val_]

These are cluster discovery MACs. You need to disable snooping on adjacent ports, AFAIK

[AkosBakos]

Did you install the one and only JHF on the top of the R82, right??