Hello all,
Is there an east way how to display transceiver properties like the inserted type? So far I have tried through clish show interface ..,
[Expert@gw-4370e6:0]# ethtool eth3-01
Settings for eth3-01:
Supported ports: [ FIBRE ]
Supported link modes: 40000baseKR4/Full
40000baseCR4/Full
40000baseSR4/Full
40000baseLR4/Full
Supports auto-negotiation: No
Advertised link modes: 40000baseKR4/Full
40000baseCR4/Full
40000baseSR4/Full
40000baseLR4/Full
Advertised auto-negotiation: No
Speed: Unknown!
Duplex: Unknown! (255)
Port: FIBRE
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
Link detected: no
Above, I am not sure whether the transceiver was even installed, in case of this 2-port 40G card, shouldn't it described it as external instead of internal? I have tried ethtool -m eth3-01, or ethtool -e but it seems these option are not supported in Gaia.