Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
dj0Nz
Advisor

CPAP-5600 power supply

Mates,

just found a bunch of 5600 HPP appliances in a customer network (running R80.40)  which show a strange behaviour: 

  1. Power supply status reports as "Dummy" ("show sysenv ps"). All of them use two (correctly cabled) power supplies.
  2. ipmi service does not start: starting the service takes unusual long time and ipmitool produces "could not open /dev/ipmi0" and "unable to open sdr for reading" errors.

To make things worse, not all of the appliances behave this way. Some of them show power supplies as expected (up/up). Ipmi does not work on any of them but on all other (6000, 5200) appliances.

Any ideas? Are there any special images to install 5600 appliances?

Cheers,

Michael

0 Kudos
4 Replies
G_W_Albrecht
Legend Legend
Legend

I would contact TAC to look into this...

CCSP - CCSE / CCTE / CTPS / CCME / CCSM Elite / SMB Specialist
0 Kudos
dj0Nz
Advisor

Thanks for replying. Actually, I thought so, too. But there was a small chance that this is a known issue and someone pops up with a "just set the chicken blood flag to zero and reboot" message... 😎

0 Kudos
G_W_Albrecht
Legend Legend
Legend

Yes, and sometimes it is just like that - only rather seldom 😎. Sounds like RMA...

CCSP - CCSE / CCTE / CTPS / CCME / CCSM Elite / SMB Specialist
0 Kudos
dj0Nz
Advisor

Hm. It's not only one but several appliances facing similar issues. I have a strong feeling that RMA would not be the right approach. I'll try with a TAC case.

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events