- Products
- Learn
- Local User Groups
- Partners
-
More
Join Us for CPX 360
23-24 February 2021
Important certificate update to CloudGuard Controller, CME,
and Azure HA Security Gateways
How to Remediate Endpoint & VPN
Issues (in versions E81.10 or earlier)
IDC Spotlight -
Uplevel The SOC
Important! R80 and R80.10
End Of Support around the corner (May 2021)
Hi,
We recently added new hardware (3100 and 5600 Appliances) on R80.10. They seem to be very slow with responses to CLI commands.
Log in through SSH it takes about 8 seconds after I enter the username to get the password proomt and after entering the password it takes up to 25 seconds to get the CLI prompt ( I am using local username and password).
Logging in through Console is instantly.
When in expert mode trying to get the ARP table is very slow too. It give one entry at a time and about 2-3 seconds between entries.
I was wondering if anyone has the same experience and whether it is something that is related to R80.10 or the new appliances? We only run R80.10 on the new appliances and the management server (open server) and the management server responds instantly for both log in and the "arp -a" command.
What can be done to make CLI faster? CPU usage is very low. all 4 CPU's are 95% or more idle.
Thanks.
Jan
Check your firewall's Gaia DNS server configuration, the servers you have configured aren't reachable. If these boxes are not yet deployed on your production network where the DNS servers are located, simply unconfigure all Gaia DNS servers until the appliances are put into production.
Thanks Tim,
You were right. The primary DNS server that I was given seems not responsive. As soon as I changed that to the IP address of the secondary it was fine.
Jan
About CheckMates
Learn Check Point
Advanced Learning
WELCOME TO THE FUTURE OF CYBER SECURITY