Auto-Connect Endpoint VPN Client

[fatalXerror]

Hi Guys, We are using before SecuRemote client and from that software, we can do automatic login for VPN from its settings.

Now, we are using Endpoint VPN Client E80.x and I found out that there is no where to configure to auto-login in the endpoint client itself. How can we do that for this endpoint client?

Thanks

[Maarten_Sjouw]

It all depends on the settings you have in the Global Properties under Remote Access - Endpoint Connect. Default setting here is Configured on Endpoint Client, but you can change the connect mode to Always connect.

I don't have a installed client handy, so I can't check the client side for you.

[fatalXerror]

Hi Maarten Sjouw‌, 

I tried to configure it but it does not resolve our concern.

What I did is to enable the password caching and set the method to always-connect. Then I tried to connect using my Endpoint Security client, I can connect successfully but when I tried to disconnect, my password does not cached in the password field and also it does not connect automatically.

Is my expectation correct or not? All I want is to automatically connect to VPN once it detects internet connection or once the user logs into their computers.

Thanks

[Maarten_Sjouw · Accepted solution]

When you disconnect, by selecting disconnect from the VPN client menu, the password cache is cleared.

Do keep in mind that these type of changes sometimes take a little time to take effect, at least you will need to reconnect and sometimes reboot the client pc.