Advertising default gateway through BGP

[Blason_R]

Hi Team,

I have two firewalls being managed by same management server. These two firewalls are separated in two different office premises however I have a fiber running between those. I need to construct Internet redundancy between those for HO Firewall

I have two ISPs at DC hence if Internet link at HO goes down the default gateway for HO will be 10.10.20.20; else will have a static gateway configured.

I am planning to configure eBGP between HO and DC firewall; since static route has a AD distance 1 it will be picked up on HO firewall while eBGP AD is 20 it will be used as a backup.

I already achieved on other platform using BGP however I am not finding a way on Check Point. Can someone please help?

 

[Chris_Atkinson]

Most likely you will need to configure BGP with route-maps ( sk94765 / sk100501 ) to allow the necessary routes in/out.

How does the DC firewall learn about it's own default route, via BGP or other routing protocol(s)?

[Blason_R]

DC does not need to know any routes except 10.10.30.0/24 and its all static routes configured which is default route. Currently the only requirement is routes should be learned from HO firewall and not vice-versa except 10.10.30.0/24.

[Chris_Atkinson · Accepted solution]

The below assumes the underlying BGP session is setup/established (basic example only).

Network: 0.0.0.0/0

DC (Advertise)

Route Redistribution from Static to BGP(65001) matching default route.

HO (Receive)

Inbound route filter for BGP allowing routes from AS65000

Network: 10.10.30.0/24

HO (Advertise)

Route Redistribution from Interface/Static to BGP(65000)

DC (Receive)

Inbound route filter for BGP allowing routes from AS65001

[Blason_R]

OK - BGP Route learning; I really feel is pretty complicated in Check Point. Honestly this is much simpler in Cisco or Vyatta or even in zebra/quagga

[Chris_Atkinson]

Yes it's different, things are done with a security flavor rather than just accept all.

One of the main shortcuts Cisco offers is the concept of "default-originate" in the peer config.