- Products
- Learn
- Local User Groups
- Partners
- More
Check Point Jump-Start Online Training
Now Available on CheckMates for Beginners!
Why do Hackers Love IoT Devices so Much?
Join our TechTalk on Aug 17, at 5PM CET | 11AM EST
Welcome to Maestro Masters!
Talk to Masters, Engage with Masters, Be a Maestro Master!
ZTNA Buyer’s Guide
Zero Trust essentials for your most valuable assets
The SMB Cyber Master
Boost your knowledge on Quantum Spark SMB gateways!
As YOU DESERVE THE BEST SECURITY
Upgrade to our latest GA Jumbo
CheckFlix!
All Videos In One Space
hi:
im connecting to my appliance (office mode) after 10 sec i get vpn tunnel has disconnected:site is not responding
I have seen this article https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...
But I could not understand so much and i don't have SmartDashboard
Look into SMB Logs and RA VPN client logs !
when connected vpn log say remote access client IP address and port were changed Old IP xxx.xx.xx.xx old port 59443 new IP xxx.xx.xx.xx new port 54280
after that at the same time vpn log block
Which client are you using - CP does not use port 59443 or port 54280 at all.
thank you
first my router was connected as a dhcp client to my isp router that have is own rules so i replaced it another route and put it on
bridge mode. that solve my other Q' post and i can connect 2 isp users on one line 🙂
for the vpn i'm using ddns from no-ip .add user with password i have established vpn connection to my site
now i'm connecting with my username and password but i don't see any user connected and no tunnel
anything to radius? or site to site?
Just my personal opinion, you would be better off to contact TAC, so they can review the config, just to make sure its correct. Its a bit difficult for us here to tell you why this is failing, unless we have clearer picture of the config for RA vpn. Did you follow below document?
page 11
As Gunther said, look for local logs on the appliance...thats your best bet. Also, if I were you, I would try few other clients, see if behaviour is the same, if it is, then its most likely issue on your firewall.
Andy
@PhoneBoy - can you relocate the post to SMB ?
done
About CheckMates
Learn Check Point
Advanced Learning
YOU DESERVE THE BEST SECURITY