Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Marcus_Halmsjo
Contributor

SIC with dynamic address 1530

Jump to solution

Hi,

I am having some issues getting SIC to work with DAIP 1530 and hoping someone has any pointers.

Starting SIC works but after 1530 has started the connection and 1530 is pulling policy it fails.
If i test communication status on 1530 it is green and management server name is shown.
status on gateway object in management is "Trust established" but if i test sic status it says:

SIC Status for GW: Not Communicating

Peer sent wrong DN: CN=c*****.*7** Reset SIC from peer, and establish trust again. **

If i change gateway object to static and sets currect IP SIC works fine on all tests and 1530 can pull policy.

It there some something more to do with DAIP gateways, tried searching SKs and check the admin guide and can't really find anything that notes DAIP limitations.

Management is R81 jumbo 58 and SMB is 1530 with R80.20.02

0 Kudos
1 Solution

Accepted Solutions
Marcus_Halmsjo
Contributor

Used wrong external NAT IP for management on the gateway when establishing SIC, when i used the IP that was set under NAT on management object it worked.

View solution in original post

0 Kudos
3 Replies
Marcus_Halmsjo
Contributor

Used wrong external NAT IP for management on the gateway when establishing SIC, when i used the IP that was set under NAT on management object it worked.

0 Kudos
G_W_Albrecht
Legend
Legend

Firmware R80.20.02 is rather outdated ! I would suggest at least fw1_vx_dep_R80_20_40_992002665

CCSE CCTE SMB Specialist
0 Kudos
Marcus_Halmsjo
Contributor

Indeed thanks for the reminder forgot it reverts to factory image on reset

0 Kudos