Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
leonid1890
Contributor
Jump to solution

Change ARP Entery

Hello,

I have Check Point's 1590 Appliance R80.20.50

I am trying to change ARP aging timeout.

I didn't find any reference about it beside sk42182 
which said to chage it in /etc/sysctl.conf -> but it isn't located there.

I found it (/etc/sysctl.conf) in different location "/sbin/sysctl"
but I see everthing there in gibberish.

 

0 Kudos
1 Solution

Accepted Solutions
G_W_Albrecht
Legend
Legend

sk42182 is for SPLAT & GAiA and not supported on GAiA Embedded ! You can use sysctl -a | grep gc_stale_time to get the current time span, but a .conf file is not present. So only the following command can be used:

[Expert@seven-eleven]# sysctl -w net.ipv4.neigh.WAN.gc_stale_time=120

This will set net.ipv4.neigh.WAN.gc_stale_time = 120 ! To make the change permanent you have to addf the sysctl -w lines to userScript, see sk52520: How to run commands at boot on an SMB appliance -- userScript

CCSE CCTE CCSM SMB Specialist

View solution in original post

1 Reply
G_W_Albrecht
Legend
Legend

sk42182 is for SPLAT & GAiA and not supported on GAiA Embedded ! You can use sysctl -a | grep gc_stale_time to get the current time span, but a .conf file is not present. So only the following command can be used:

[Expert@seven-eleven]# sysctl -w net.ipv4.neigh.WAN.gc_stale_time=120

This will set net.ipv4.neigh.WAN.gc_stale_time = 120 ! To make the change permanent you have to addf the sysctl -w lines to userScript, see sk52520: How to run commands at boot on an SMB appliance -- userScript

CCSE CCTE CCSM SMB Specialist

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events