Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Wyman
Contributor

CP 1450 - Get Interfaces Option

Jump to solution

Hi all. I'm in the middle of configuring a VTI on a 1450 appliance at one of our remote offices. When I've updated interfaces in SmartConsole for our other firewalls (5200s) I choose 'Get interfaces without topology'; the options for the 1450 are 'Get interfaces' and 'Get interfaces with topology'.

Before I press anything, I want to make sure that the correct option for the 1450 appliance will be 'Get interfaces'. Thanks in advance.

0 Kudos
1 Solution

Accepted Solutions
G_W_Albrecht
Legend
Legend

I would suggest to use Get Interfaces - get with topology can result in glitches that have to be corrected later, see sk105380 for two examples.

View solution in original post

0 Kudos
4 Replies
G_W_Albrecht
Legend
Legend

I would suggest to use Get Interfaces - get with topology can result in glitches that have to be corrected later, see sk105380 for two examples.

View solution in original post

0 Kudos
G_W_Albrecht
Legend
Legend

Any feedback, did you succeed ?

0 Kudos
Wyman
Contributor

Hi. Sorry for the delay. Yes, all was well in the end. Thanks very much!

0 Kudos
G_W_Albrecht
Legend
Legend

You are always welcome 😎

0 Kudos