SAML FOR CAPSULE VPN

[ikokkoris]

Hello,

I have seen that Capsule VPN does not support SAML authentication in R81.10

Is it going to been solved in R81.20 ?

[Chris_Atkinson]

Suspect we will know more only post release of R82 and/or a compatible Capsule client version.

[PhoneBoy]

Actually, R81.10 with a recent JHF has support for this on the gateway side: https://sc1.checkpoint.com/documents/Jumbo_HFA/R81.10/R81.10/R81.10-List-of-all-Resolved-Issues.htm?...
It needs a compatible client version, which I don’t believe is released yet.
It’s also not in other JHF branches yet that I’ve seen.

Your best bet is to reach out to your local Check Point office and have them reach out to our Solution Center.
I suspect this functionality is considered a customer release and you may be able to obtain access to it.

[ikokkoris]

Hello,

Below the response from local office.

I have to wait until Take 113 for R81.10 is recommended to solve this one.

There is no info yet for R81.20 (in case of an upgrade).

[PhoneBoy]

That doesn’t speak to the required Capsule VPN client version, which I assume requires an update to support this authentication flow.

[ikokkoris]

You mean both update of capsule VPN version and Take 113?

[PhoneBoy]

Based on past experience, more than likely.

[PhoneBoy]

Looks like support was added in JHF 43:

[ikokkoris]

Hello,

I have tested with R81.10 and Take 129 and it works properly, so JHF 43 should be fine too.

Thank you 

[Chris_Atkinson · Accepted solution]

sk181494 was updated