split tunnel vpn traffic not working

[nflnetwork29]

when i check route print on my windows PC I can see the proper routing entry that should be sending traffic over the checkpoint vpn . However, when i run any traceroute it looks like the traffic is going out my internet connection. what am i missing?

IPv4 Route Table
===========================================================================
Active Routes:
Network Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 10.172.253.1 10.172.253.63 35
10.54.0.0 255.255.128.0 172.16.10.2 172.16.10.1 1
10.172.253.0 255.255.255.0 On-link 10.172.253.63 291

C:\>tracert 10.54.152.200

Tracing route to 10.54.152.200 over a maximum of 30 hops

1 3 ms 2 ms 2 ms 10.172.253.1
2 1 ms <1 ms <1 ms ^C
C:\>

[the_rock]

Make sure below options are enabled, as that will force all traffic via the CP firewall and NOT your ISP. If they are disabled, like in my case, that counts for split vpn tunnel.

Andy

 

 

[nflnetwork29]

i don't want all traffic to go thru the checkpoint only the networks defined in my encryption domain. 

[the_rock]

Fair enough...can you ensure those options are disabled then?

Andy

[nflnetwork29]

still not working. something buggy going on. 

[nflnetwork29]

its working now. thanks, 

[the_rock]

Anything changed or was it just PC you were testing from?

[nflnetwork29 · Accepted solution]

subnetting mishap lol on the enc domain . 

[the_rock]

it happens 🙂