Which CLI command shows if active SmartCenter is HA?

[Danny]

Below commands are returning 1 on SmartCenter Servers (Non-HA) and primary active SmartCenter HA-Servers.

cpprod_util FwIsActiveManagement
cpprod_util FwIsHAManagement
cpprod_util FwIsFirewallMgmt
cpprod_util FwIsPrimary

However, cpview is able to differentiate between both.

sk148112 assumes the commands are executed on a SmartCenter HA server but doesn't provide a hint how to differentiate between a single active SmartCenter and a Primary Active SmartCenter HA.

Which command shows if I'm actually on an primary active SmartCenter-HA?

[Danny]

Working with this now:

if [[ -e $MDS_FWDIR/conf/peers.C ]]; then echo "SmartCenter HA"; fi

[Ziegelsambach]

Would be interesting to know how cpview gets the info.

[Tal_Paz-Fridman]

You can also run cpstat mg:

[Ziegelsambach]

Thanks @Tal_Paz-Fridman,

unfortunately cpstat mg cannot differentiate if the management is HA or not.

On single managements cpview and cpstat show:

On Management-HA:

[Tal_Paz-Fridman]

But it will tell you if it is Active or Standby so perhaps that might help?

[Ziegelsambach]

Thanks @Tal_Paz-Fridman,

we want to know if the management is HA or not.

It doesn't matter at this stage if it's active or standby.