Small annoyance in SmartConsole JHFA installation process

[Vladimir]

During the installation of JHFA from SmartConsole, in Steps, cluster member is referred to as Active when in Standby mode:

active instead of standby

[Boaz_Orshav]

Hi

Indeed I can see the mis-leading statement

We always install on standby so do you think that "former active member" will be clearer?

[Vladimir]

Either that, or simply use 'Current Standby member'.

In typical configurations, active members are not pinned to specific gateway, Then there are edge cases with more than two members HA clusters. This, i think, making current standby choice better. Else, you'll have to track active members after each one is upgraded.

Thank you for looking into this.