Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Andrey_Ganichev
Participant
Participant
Jump to solution

R80.20 Management and vpn domain Edge N

Hello,

We plan to update MGMT (MDS) R77.30 to R80.20. This MGMT manages geteways including Edge N/X. Edge N is referred to as supported by R80.20. But when testing we found out that to Edge N not transmitted vpn domain behind central cluster and traffic inside tunnel does not work. Has anyone faced this issue? While there is a temporary solution to transfer these devices to local management or to the dedicated MGMT R77.30.

Andrey

0 Kudos
1 Solution

Accepted Solutions
Wolfgang
Authority
Authority

Andrey,

we observed the same.

If you don‘t use VPN with the edges everything will be fine. The tunnel is established but no traffic is going this way.

A workaround is, to not install R80.20 policy to the edge device or the LSM-profile if used. But with this workaround you can‘t change anything at the policy for the edges.

We used these, because we were on the way of replacement of the edges with 14xx appliances. This worked for us for an half year, now we replaced all edges and we can change the policy for the new 14xx.

We never opened a case for this.

Wolfgang

View solution in original post

0 Kudos
7 Replies
PhoneBoy
Admin
Admin
Recommend a TAC case so we can investigate.
0 Kudos
Andrey_Ganichev
Participant
Participant

TAC with RnD are investigating this issue. We are waiting the result.

 

Andrey

0 Kudos
RicardoI
Explorer

hi, any solution, i have the same issue with a N Edge in R80.30, problem with the traffic in the vpn

0 Kudos
Wolfgang
Authority
Authority

Andrey,

we observed the same.

If you don‘t use VPN with the edges everything will be fine. The tunnel is established but no traffic is going this way.

A workaround is, to not install R80.20 policy to the edge device or the LSM-profile if used. But with this workaround you can‘t change anything at the policy for the edges.

We used these, because we were on the way of replacement of the edges with 14xx appliances. This worked for us for an half year, now we replaced all edges and we can change the policy for the new 14xx.

We never opened a case for this.

Wolfgang

0 Kudos
Andrey_Ganichev
Participant
Participant

Wokfgang,

Thanks. I'll keep that in mind. We can't replace all Edge N/X to 14xx quickly too.

Andrey

0 Kudos
G_W_Albrecht
Legend
Legend

VPN-1/UTM-1 Edge X is out of support since 31-May-2015, UTM-1 Edge N since May-2018 - but as the R80.20 Release Notes state that it can manage UTM-1 Edge N 8.1 and higher, something is missing here... Only UTM-1 Edge Industrial has support until 26-May-2020.

CCSE CCTE CCSM SMB Specialist
0 Kudos
miko_it
Explorer

Andrey,

We noticed the same, but installing R80.10 did work. Now we'll see to get the latest UTM Edge N replaced by a newer edge but at least it works.

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events