Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Hitesh_Brahmbha
Participant

Policy installation failed on gateway - (Error code: 2000235)

Error Message on Policy Installation in Smartconsole: "Policy installation failed on gateway. If the problem persists contact Check Point support (Error code: 2000235)."

 

Error Message in cpd.elg - "Installation failed. Reason: Load on Module failed - failed to load security policy"

 

Resolution: If LSMenabler is in on state on security gateway, it will not allow to install policy and generate the above error message in the SmartConsole.

 

Off LSMenabler using below commands in expert mode:

Usage: LSMenabler [-d] [-r [-DynObj=<central|local>]] <off|on> [-y/-n]

if central is enabled, perform below command to off the central LSMenabler

e.g. LSMenabler -d -r -DynObj=central off -y 

 

if local is enabled, perform below command to off the local LSMenabler

e.g. LSMenabler -d -r -DynObj=local off -y 

0 Kudos
1 Reply
PhoneBoy
Admin
Admin

I’m assuming this is something you ran into?
Makes sense a traditional policy install would fail since when you use LSM the policy installation process is different.