Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
babasahebb
Explorer

Object limitation in R80.10

I am facing a slowness issue while adding more than 1500 objects in a single Object group/policy in R80.10.

Please help.

Thanks,

Sunil 

 

 

0 Kudos
8 Replies
PhoneBoy
Admin
Admin

Are you trying to add them all at once?
I would try to add them and publish changes in smaller chunks as trying to do 1500 at once is likely to take a while, even if you were doing this via the API.
Especially on R80.10, which is almost End of Support.
It's probably a good idea to look at upgrading to a more recent release.

0 Kudos
babasahebb
Explorer

Thanks, PhoneBoy,

I am trying to add a very small amount but after goes count more than 1500, its works very slowly.

Will this issue resolve after upgrading to R80.20 / R80.30?

Thanks,

 

 

0 Kudos
G_W_Albrecht
Champion
Champion

I would assume yes - but it is of no real importance as R80/R80.10 are out of support starting May 1st 😎 Why not upgrade to R80.40 ?

0 Kudos
babasahebb
Explorer

will go for an upgrade and share feedback on this.

Is there any other solution with-out upgrading?

0 Kudos
G_W_Albrecht
Champion
Champion

You should look at performance, the load on SMS when the issue occurs compared to load before this object limit cuts in.

0 Kudos
babasahebb
Explorer

Thanks,

We are monitoring the load of SMS, will update you on this.

0 Kudos
PhoneBoy
Admin
Admin

First off: why are you adding more than 1500 objects to a rule? 
Or more specific: what precise steps are you taking?
Are you adding these objects directly to a rule, a group, or?
Based on that, perhaps we can suggest a way of working that would make more sense if you really don't want to upgrade.

Note that I can't say for sure that upgrading will solve the issue.
However, given that R80.10 is almost end of support, it's highly recommended.
There is zero reason to upgrade to R80.20/R80.30 at this point, go to R80.40 (the current widely recommended release).
There are significant improvements and fixes between R80.10 and R80.40.
If the issue still persists in R80.40, the odds of receiving a bugfix for it are much higher given where R80.10 is in its lifecycle. 

0 Kudos
babasahebb
Explorer

Thanks, Guys for your reply.

We are planning to upgrade to R80.40, will come back with feedback post-upgrade.

0 Kudos