Installation Check Point Gaia R80 Stuck (bootable from USB)

[Muhammad_Naufal]

Hai gais,

I have a problem, when factory default Check Point GAIA.
I have used several methods:
1. Bootable from USB. Install R80.10


2. Bootable USB. Install R80.20

3. Factory default to R80.10 and R77.30

Issue, because i have upgrade a secuirity gateway, vsx configuration to R80.30. i found error this

Info: Initiating upgrade of Check_Point_R80.30_T200_Fresh_Install_and_Upgrade_Security_Gateway.tgz...
Interactive mode is enabled. Press CTRL + C to exit (this will not stop the operation)

Result: Upgrade a VSX with Non-DMI configuration is not supported
Upgrade to this version is prohibited. Use clean install.
Contact Check Point Technical Services for further assistance.

Please kindly support

Best Regards,
Muhammad Naufal

[_Val_]

What do you use as USB device?

[_Val_]

Regardless, do clean install with Blink (sk120193) and then run vsx_util reconfigure to set up your VSX GW