Enable Rule UID

[J_Saun]

We have a requirement to enable/use Rule UID on all of our management stations (its a mix of R65, R72, R77).

To enable this feature I need to check the following option in Global Properties:

'Smardashboard Customizations>Advanced>Firewall-1>General - rulebase_uids_in_log'

Before going into the advanced section there is a note that says 'recommended to contact Checkpoint technical support before modifying these values'.

Is that necessary? What impact (if any) does enabling rulebase_uids_in_log have?

[PhoneBoy · Accepted solution]

It’s a generic warning for other items in that section. That particular setting, since it’s the default setting in new installs should be fairly safe to enable.

[J_Saun]

We enabled Rule UID via Global properties but we were unable to push policy once this feature was enabled. We receive "load on module failed: no memory."

I've rules out most of the causes from sk101875.

Has anyone run into this issue? If so, what was your fix?