Check SIC status without SmartConsole on Management

[Anthony_Joubai1]

Hello,

I'm looking for Checking Sic Status on CLI instead of Smartconsole.

I know how to set it on CLI on Management side. push cert commands

I know how to set it on CLI on Gateway side. cp_conf commands.

I know how to check status on CLI on Gateway side. cp_conf commands.

Do we have a way to "Test Sic Status" on CLI on a GAIA management (with 28 firewalls associated).

regards,

Anthony Joubaire

[G_W_Albrecht · Accepted solution]

You could run some innocent commend like ver from SMS following sk101047: How to manage Security Gateway using the "cprid_util" tool - cprid_util needs a working SIC, so it will fail if it is not established. The sk also shows how to send it to several GWs at once...

[G_W_Albrecht]

P.S.: Nice tool to do that is found here:

GAIA - Easy execute CLI commands on all gateways s...

[Nick_Doropoulos]

Hi Anthony,

The quickest way would be to use the cpconfig command:

1. Connect to the command line on the Security Gateway / Cluster member (over SSH, or console). 

Note: For cluster, perform this procedure on Standby member first and then on the Active.

It should say "Trust Established" as highlighted in blue below:

I hope this helps.

[G_W_Albrecht]

Did you read the title ? It is : Check SIC status without SmartConsole on Management.

Did you read the users question at all ? It went : I know how to check status on CLI on Gateway side. cp_conf commands.

So he wants to know how to check SIC of GWs from SMS CLI !