CPview on R80.30 wrong Mbps indications

[marcinw]

Hi , 

Just after upgrading from 77.30 to 80.30 I've noticed that cpview shows wrong bandwidth utilization, I run speedtest with 100 Mbs but cpview show around 10 (please check attachment) Is there any bug or do I have to configure something ?

[the_rock]

I checked this for couple of my customers and its very accurate. Though they are both on R80.40 version, cant speak for R80.30...maybe you can check with TAC on it.

Andy

[marcinw]

sorry, actualy you are right FW is on 80.30 , but mgmt 80.40, so it is working for you not for me 

[the_rock]

Well, that should not matter at all actually...you might want to open TAC case and have them check, for sure.

Andy

[the_rock]

By the way, maybe I calculated this wrong, where did you get number 10 Mbps from that screenshot?

[marcinw]

The last column "Mbp" shows 10 times less value than should 

[the_rock]

Normal;ly, I always look at the end where you add them all together or did you only calculate for one specific interface?

[marcinw]

on 77.30 I had no problem with that, bandwidth utilization was always accurate on each interface , also I see there is no "top protocols" , "top connections". 

[the_rock]

Sorry, but Im out of ideas really...I would suggest open TAC case and show them exactly that. I cant say for sure if its something with R80.30, but I had not seen this problem in R8040, so one thing you could do is upgrade the firewall.

Andy

[PhoneBoy]

The issue with Top Protocols is fixed with a recent JHF.
See: https://supportcenter.checkpoint.com/supportcenter/portal?action=portlets.SearchResultMainAction&eve...