Environment : MHO-175 + 2 * 26000 Appliance.
I have configured a bond called bond8, with 4 physical interfaces, and have create a vlan (vlan 660) on it.
On the switches end, fours ports were configured as ether channel and connect to this firewall. However, one of the switch port is not configured properly, therefore the status of this port is suspend, but the ether channel is still up because the other three ports are working properly.
On the firewall end, I can see this bond8 is also up, that make sense because the ether channel is up.
The question here is, because one switch port is suspend, the connected firewall interface must also be down. Without checking the switch (because I don't manage the switch), how do I check the firewall network interface and know which interface is not working?
I used this command : asg if, to list the status of all interfaces. For those bonds without vlan, it showed the status of the physical interfaces. However for those bond which configured with vlan, it did not show the status of physical interfaces.
Please see the output below. for bond8 which has vlan 660 no details status of the physical interface. For bond10 it shows the status of the two physical interfaces.
So for daily maintenance, how do I see the status of each physical interface?
Thanks.
Regards,
