Configuring Cisco ACI/Nexus Switch Ports for Maestro R81.20 Running in VSX

[PrasannaRout]

Is there any standard documents for Configuring Cisco ACI/Nexus Switch Ports for Maestro R81.20 Running in VSX .

For each Bond, there are total 4x10G ports ( 2 connection goes to 1st MHO & 2 connection goes to 2nd MHO) configured in LACP 802.3ad |Load Sharing . How ever, traffic can be seen in only in 2 connection goes to 1st MHO. 

How does the traffic load balancing is happening . What changes we need to do both at CISCO & CHECKPOINT side so that we will get 40G output. 

Are all 4 MHO Ports acts as ACTIVE-ACTIVE ? we are using MHO140 

[emmap]

All ports in the bond are active, it is a single LACP bond with all four ports in it. The switches should be configured as such too.

[PrasannaRout]

Do you have any supported documentation to Cisco Catalyst Switch Side configuration in order to support Maestro VSX.

changed hash-policy to L3,4 for all bonds. auto-negotiation enabled for BOND .

We can see traffic in all 4 ports. However we see FCS & Receive errors in Uplink switch Ports 

switch#show interfaces counters errors

Port           Align-Err     FCS-Err    Xmit-Err     Rcv-Err  UnderSize  OutDiscards

Te1/0/3                0          30           0          93          0            0

Te1/0/4                0           6           0         138          0            0

Port           Align-Err     FCS-Err    Xmit-Err     Rcv-Err  UnderSize  OutDiscards

Te2/0/3                0         186           0         613          0            0

Te2/0/4                0          12           0         113          0            0

[Chris_Atkinson]

Further to the advise from Emma setting the correct hashing for your environment may also be a factor.

[PrasannaRout]

changed hash-policy to L3,4 for all bonds. auto-negotiation enabled for BOND .

We can see traffic in all 4 ports. However we see FCS & Receive errors in Uplink switch Ports 

switch#show interfaces counters errors

Port           Align-Err     FCS-Err    Xmit-Err     Rcv-Err  UnderSize  OutDiscards

Te1/0/3                0          30           0          93          0            0

Te1/0/4                0           6           0         138          0            0

Port           Align-Err     FCS-Err    Xmit-Err     Rcv-Err  UnderSize  OutDiscards

Te2/0/3                0         186           0         613          0            0

Te2/0/4                0          12           0         113          0            0

[Chris_Atkinson]

What cabling and transceivers are used, this usually points to a physical layer issue?