Pls see the screenshot:
I have a failover question，as below:
The bridge ha system version are R80.10,I did failover test with command "clusterXL_admin down; clusterXL_admin up",everything is ok,business traffic is working when failover active to FW2.
I upgrade R80.10 to R80.40,then did failover test with command "clusterXL_admin down; clusterXL_admin up",after active faiover to FW2,business traffic interruption, i see the arp and mac table in switch ,i found arp and mac table out interface no flush,so the traffic interruption.
For example: I use source ip 126.96.36.199 under core_sw to ping dest 188.8.131.52 above (sw1&sw2).When fw1 is active,core_sw1&sw2 disply the 184.108.40.206 arp and mac out interface is port-channel1,but i failover active to fw2 with command "clusterXL_admin down; clusterXL_admin up",i see the 220.127.116.11 arp and mac out interface still is port-channel1,so traffic interruption.
The same environment of R80.10 and R80.40 ,just upgrade R80.10 to R80.40,R80.10 failover ok,but R80.40 failover not working,I want to know the difference between R80.10 and R80.40.
I also have the same problem in R80.30. I comfirm that R77.30 and R80.10 is working.