Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
PhongNN
Contributor
Jump to solution

SecureXL: fwaccel stat command does not show which rule disabled SecureXL

Hi all

I run the fwaccel stat command but i do not see which rule disabled SecureXL

[Expert@DC-Outbound-Fw-02:0]# fwaccel stat
+-----------------------------------------------------------------------------+
|Id|Name |Status |Interfaces |Features |
+-----------------------------------------------------------------------------+
|0 |SND |enabled |eth1-01,eth1-02,eth1, |
| | | |eth2,eth8,Sync |Acceleration,Cryptography |
| | | | |Crypto: Tunnel,UDPEncap,MD5, |
| | | | |SHA1,NULL,3DES,DES,CAST, |
| | | | |CAST-40,AES-128,AES-256,ESP, |
| | | | |LinkSelection,DynamicVPN, |
| | | | |NatTraversal,AES-XCBC,SHA256 |
+-----------------------------------------------------------------------------+

Accept Templates : disabled by Firewall
Layer ---Drop Templates : enabled
NAT Templates : disabled by Firewall
Layer ---

I ran R80.30 version

Is it expected behavior ?

Thank you

Regards

0 Kudos
1 Solution

Accepted Solutions
Timothy_Hall
Legend Legend
Legend

This is a known issue, the name of your Network policy layer is too long.  If you shorten it to under 32 characters the fwaccel stat display should work properly again.

sk145533: "Layer ---" is displayed instead of specific layer name and rule number in output of 'fwac...

Gateway Performance Optimization R81.20 Course
now available at maxpowerfirewalls.com

View solution in original post

3 Replies
_Val_
Admin
Admin

The normal output for R80.10 and up should look like this:

Accept Templates   : disabled by Firewall
                     Layer <Name_of_Layer> disables template offloads from rule #<N>
                     Throughput acceleration still enabled.

However, some features on FW can disable templating altogether, for example Network quota.

0 Kudos
Timothy_Hall
Legend Legend
Legend

This is a known issue, the name of your Network policy layer is too long.  If you shorten it to under 32 characters the fwaccel stat display should work properly again.

sk145533: "Layer ---" is displayed instead of specific layer name and rule number in output of 'fwac...

Gateway Performance Optimization R81.20 Course
now available at maxpowerfirewalls.com
krit
Participant

Dear Mr. Hall,

Thank you for this reply, it resolved the same issue I had.

Just to add that the initial policy name was 26 chars and I shortened it to 16 in order to be displayed properly ( R80.20 environment )

Best Regards,

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events