R80.40 Upgrade device in standalone

[v1K1]

Hi Team,

I have upgrade my vsx cluster running 2 virtual machine (both in HA) FROM 80.30 to 80.40. I have followed the upgrade using cli.

Post successfully upgrade, The standby device went to the standalone mode and lost the connection to active device.

Any help is appreciated. 

[Chris_Atkinson]

Standalone is usually a term implying management and gateway functions run on the same machine, not something that is supported with VSX. Do you mean active / active or some other cluster state?

With that said please review the following and if your problem persists please investigate further with TAC.

sk174510, sk42096, sk169777

[v1K1]

The issue i experiencing was after upgraded one of the vsx gateway to r 80.40 the device booted with ready mode instead standby mode.

ha configure : yes

[Chris_Atkinson · Accepted solution]

That makes more sense, this SK is the place to start in that case.

sk42096: Cluster member is stuck in 'Ready' state

[v1K1]

Thank you @Chris_Atkinson. Its resolved my issue