Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Mike567
Explorer

Gaia install issue

Hi

I am required to simulate 5 checkpoint firewalls.

About 18 months ago I have downloaded the iso: Check_Point_Install_and_Upgrade_R76.Gaia.iso

and had no problems installing it on VirtualBox VM.

In short I have installed Gaia R76, set expert-password, ran expert and from expert mode ran"fw unloadlocal", then connected to Gaia via IE and ran First Time Wizard, then rebooted, went into expert and again ran "fw unloadlocal", then access Gaia via IE and went to configure it etc.

However now I can't event run "fw unloadlocal", it spits out error:
"Local host is not a Firewall-1 module"

Any attempts to access web GUI from any browsers giving me following error:

192.168.1.80 uses an unsupported protocol.

ERR_SSL_VERSION_OR_CIPHER_MISMATCH
I am kind of stuck and any help will be very appreciated.
I have Searched the web, checked browser security settings to no success.
 
Also I have tried following ISO:
Check_Point_R77.30_Install_and_Upgrade_T5.Gaia.iso
and
Check_Point_R80.10_T479_Gaia.iso
with the same result.
 
 
Thank you
Mike
 
 

 

 

 

 

0 Kudos
4 Replies
PhoneBoy
Admin
Admin

Need some more details about the browser/version/OS you are using to do this.

But most likely this is relevant: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...
0 Kudos
Vladimir
Champion
Champion

You are using an old ISO support for encryption suite for which is disabled in modern browsers.

The "unloadlocal" may not work because you may have configured it as a Management Server during FTW.

 

To connect to it via browser, find an outdated self-contained installer for IE or Firefox that supports SSL2.0 and enable it.

0 Kudos
Mike567
Explorer

Thank you Vladimir!

I have downloaded R77 iso, Check_Point_R77.30_Install_and_Upgrade_T5.Gaia.iso and installed it on ESXi5.5.
I was able to login with IE and Edge, but FTW got stuck on Management Connection.
I have verified the IP addresses and clicked on Next button which was active, after which all buttons got greyed out and nothing is happening, it is just sitting there, please see the attached screenshot.

Any advice here?

I feel quite stupid actually as it seems that I am missing very basic things...

Thanking you again for your help!

 

0 Kudos
PhoneBoy
Admin
Admin

Known issue, especially if you have not applied a recent Jumbo Hotfix.
See here: https://community.checkpoint.com/t5/General-Management-Topics/Cannot-Connect-with-SmartConsole-to-R7...
0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events