Configuring dynamic routing in clustered VSX

[Vladimir]

I have run in to the situation where dynamic routing should be implemented on virtual systems in a clustered VSX environment. Can someone tell me if it should be done only on VS' on active cluster member and it will be automatically replicated, or should it be setup on each instance of VS?

Thank you,

Vladimir

[Bob_Zimmerman]

R81.20 also has this option. I'm not sure if R81.10 has it. It's "Network defined by routes". It sounds promising, but I had some trouble getting it to work reliably with OSPF when I tried. That was a while ago, so it may work better now than I remember.

[Matlu]

Hello,
In OSPF scenarios, is it advisable to “remove” Antispoofing from the interfaces involved in the process?
If you only configure OSPF on Node 1 of your VSX VSLS Cluster and “forget” to configure it on the other member, could there be problems with the “neighborhood” with the remote peer?
Cheers.

[Chris_Atkinson]

Correct OSPF wouldn't work upon failover in this instance.

[emmap]

Internal, and Defined by routes. This setting allows the gateway to figure out the topology automatically according to the routes in the kernel, so it works with dynamic routing.

[genisis__]

Great - That's what I figured.