Admin password on open server recovery

[Chandru]

Hi All,

We are using HP open server and was running R77.30, - ILO access is available for all the t-shoot

HP server model - ProLiant DL380 G7

1. coz of some reason the drive was failed

2. Drive was replaced 

3. the device was keep rebooting and doesn't come-up

4. downloaded the IOS image to local system and via virtual drives using CD-ROM/DVD option.

5. Did clean install the image and system asked for few initial setup, 

keyboard - US- set

MGMT interface and IP address and gateway - set

admin password - set very clear and simple BUT its not taking after bootup with new image. (this is problem facing)

Any advice please, thanks in advance.

[_Val_]

E77.30 is a very old version, it is out of support for ages. Even if you manage to re-install it, you won't be able to open WebUI, browsers will refuse to open due to old weak ciphers used.

[Lesley]

Only advise I can give is to either scrap this hardware or try R80 that is the latest version it can handle.

Hardware and version EOL, also R80 by the way